Where to find the new Cisco 640-822 exam questions to pass the exam easily? Now,Flydumps has publised the new version of https://www.leads4pass.com Cisco 640-822 exam dumps with new added exam questions.Flydumps offer the latest Cisco 640-822 PDF and VCE dumps with New Version VCE Player for free download, and the new Cisco 640-822 practice tests ensure your exam 100% pass.

QUESTION 91
On the basis of the exhibit below. After adding host A to the network, Host A is unable to communicate on
the network. A ping issued on the host to address 127.0.0.1 fails.
What is the problem?
A. The remote host at 127.0.0.1 is unreachable.
B. The default gateway is incorrect.
C. The IP address of host A is incorrect.
D. The TCP/IP protocols are not loaded.

Correct Answer: D
QUESTION 92
Attaching an Ethernet cable to a PC NIC and then attaching to a switch port. The PC power is turned on and the switch port link LED becomes green. Which two conditions does the link light indicate? (Choose two.)
A. Layer 2 communication has been established between the PC and switch.
B. Traffic is being sent from the switch to the PC.
C. If flashing, the green LED indicates port speed of 100 Mb/s.
D. The Layer 1 media is functioning between the PC and switch.

Correct Answer: AD
QUESTION 93
Match the corresponding terms and OSI layer.(Not all options are used.) 1.bits 2.packets 3.UDP 4.IP addresses 5.segments 6.MAC addresses 7.windowing 8.routing 9.switching
A. Network Layer II.Transprot Layer
B. I(2,4,9),II(5,7,3)
C. I(1,4,9),II(5,3,7)
D. I(1,4,8),II(2,7,3)
E. I(2,4,8),II(5,7,3)
Correct Answer: D
QUESTION 94
Three of the following are types of flow control. Which are them? (Choose three.)
A. windowing
B. buffering
C. cut-through
D. congestion avoidance

Correct Answer: ABD
QUESTION 95
The following exhibit displays every device attached to the network. How many collision domains are shown in this network?

A. 3
B. 6
C. 9
D. 15

Correct Answer: D
QUESTION 96
What do you think is the data structure that is described in the graphic?

A. TCP segment
B. FDDI frame
C. Ethernet frame
D. Token Ring frame

Correct Answer: A
QUESTION 97
For the following Layer 4 protocols, which one is used for a Telnet connection?
A. UDP
B. TCP
C. ICMP
D. DNS

Correct Answer: B
QUESTION 98
Which option is correct about the relationship between the definition and the term? Not all definitions will be used.
1.a protocol that converts human-readable names into machine-readable addresses 2.used to assign IP addresses automatically and set parameters such as subnet mask and default gateway 3.a protocol for using HTTP or HTTPS to exchange XML-based messages over computer networks 4.a connectionless service that uses UDP to transfer files between systems 5.a protocol used to monitor and manage network devices
6.a reliable. Connection-oriented service that uses TCP to transfer files between systems
A. SNMP II.FTP III.TFTP IV.DNS
B. DHCP
C. I-5;II-6;III-4;IV-1;V-2
D. I-5;II-6;III-1;IV-2;V-4
E. I-6;II-5;III-4;IV-1;V-2
F. I-6;II-5;III-4;IV-2;V-1

Correct Answer: A
QUESTION 99
Look at the following exhibit. To interconnect the devices, which types of cables are needed? (Choose three.)

A. rollover cable
B. V.35 cable
C. crossover cable
D. straight-through cable

Correct Answer: ACD
QUESTION 100
Look at the following exhibit. You are a network administrator for certways. You have added Host A to the network. A certain kind of cable should be used between P4S-S2 and host A. Which is it?

A. console cable
B. crossover cable
C. rollover cable
D. straight-through cable

Correct Answer: D
QUESTION 101
Look at the following exhibit. To make the following connections ,what types of cables are recommended?

A. A-crossover B-straight-through C-crossover D-straight-through E-crossover
B. A-rollover
B-straight-through
C-straight-through
D-rollover
E-crossover

C. A-straight-through B-straight-through C-rollover D-straight-through E-straight-through
D. A-crossover B-straight-through C-rollover D-straight-through E-straight-through

Correct Answer: D
QUESTION 102
From which of the following does a small network get its IP network address?
A. Internet Service Provider (ISP)
B. Internet Architecture Board (IAB)
C. Internet Domain Name Registry (IDNR)
D. Internet Assigned Numbers Authority (IANA)

Correct Answer: A
QUESTION 103
You are a network administrator for certways. By using the Ethernet interfaces as shown in the graphic,
you connect PC hosts certwaysA and certwaysB directly. You ping certwaysB from
certwaysA, and fails. You are required to enable the connectivity between the two hosts. What can be
done? (Choose two.)
A. A default gateway needs to be set on each host.
B. The subnet masks should be set to 255.255.255.0.
C. A crossover cable should be used in place of the straight-through cable.
D. The hosts must be reconfigured to use private IP addresses for direct connections of this type.

Correct Answer: BC
QUESTION 104
Part of the certways network is shown below:
Please study the exhibit shown above carefully, how many collision domains are shown
A. three
B. two
C. four
D. one

Correct Answer: B
QUESTION 105
What is a necessary to allow host A to ping host B according to the exhibit?

A. a straight-through cable connecting the switches
B. a crossover cable connecting the switches
C. a router connected to the switches with straight-through cables
D. a CSU/DSU connected to the switches with straight-through cables

Correct Answer: C
QUESTION 106
You work as a network technician for the P4S company. The displayed wire scheme is terminated at each end with an RJ-45 connector. Which type of cables does the wire diagram represent?

A. a rollover cable
B. an Ethernet straight-through cable
C. a serial crossover cable
D. an Ethernet crossover cable

Correct Answer: D
QUESTION 107
On the basis of the exhibit below. When packets travel from Sara to Bill, which three devices will determine a forwarding path by using the destination MAC address of the packet? (Choose three.)

A. P4S-S1
B. P4S-S2
C. P4S-R2
D. P4S-S3
Correct Answer: ABD QUESTION 108
Study the exhibit carefully. P4S-Host A is forwarding a packet to P4S-Host B for the first time. Which destination MAC address will be used by P4S-Host A in the ARP request?

A. 255.255.255.255
B. 00-17-94-61-18-b0
C. 00-19-d3-2d-c3-b2
D. ff-ff-ff-ff-ff-ff

Correct Answer: D
QUESTION 109
Refer to the following exhibit, Host A should communicate with the email server. Which address will be put in the destination address field of the frame when it leaves Host A?

A. the MAC address of Host A
B. the MAC address of P4S-S1
C. the MAC address of E0 of P4S-R
D. the MAC address of E1 of P4S-R

Correct Answer: C QUESTION 110
The following exhibit shows a planned network. Which three descriptions are true about the areas and devices in the network plan? (Choose three.)

A. Network Device A is a switch.
B. Area 2 contains a Layer 2 device
C. Network Device B is a hub.
D. Area 1 contains a Layer 2 device.

Correct Answer: ACD
QUESTION 111
Refer to the graphic. Workstation A in the Sales location is communicating with the server in the Production location. What will be the source MAC address of the frames received by workstation A from the server?

A. the MAC address of router interface e0
B. the MAC address of the server network interface
C. the MAC address of host A
D. the MAC address of router interface e1

Correct Answer: A
QUESTION 112
All devices will be connected through Ethernet according to the exhibit from labeled A to E . Which three
device-to-device configurations most likely require the use of a crossover connection?
(Choose three.)
A. exhibit A
B. exhibit B
C. exhibit C
D. exhibit D
E. exhibit E

Correct Answer: ADE
QUESTION 113
Your company has just installed the mail server and P4S-SW2. UDP packets are not permitted outbound on the Fa0/1 router interface due to security reasons. Bob is now examining the new installation at his workstation and can’t establish SMTP communication to the mail server. Which item is the reason for lack of communication between Bob’s workstation and the mail server?

A. The crossover cable should be a straight-through cable.
B. The IP addresses are all on the same network. No router is required.
C. UDP is blocked coming out of the Fa0/1 interface on the router.
D. The server should be directly connected to the router.

Correct Answer: A
QUESTION 114
Which two statements best describe the interface configuration according to the exhibit? (Choose two.)

A. The encapsulation in use on this interface is PPP.
B. This interface is connected to a LAN.
C. The address mask of this interface is 255.255.255.0.
D. The default serial line encapsulation is in use on this interface.

Correct Answer: AC
QUESTION 115
Refer to the exhibit. What could be possible causes for the “Serial0/0 is down” interface status? (Choose two.)

A. A Layer 1 problem exists.
B. A protocol mismatch exists.
C. The bandwidth is set too low.
D. An incorrect cable is being used.

Correct Answer: AD QUESTION 116
Which two statements best describe ICMP packets? (Choose two.)
A. They acknowledge receipt of TCP segments.
B. They guarantee datagram delivery.
C. They can provide hosts with information about network problems.
D. They are encapsulated within IP datagrams.

Correct Answer: CD

latest 640-822 exam is one of popular Certification.Many candidates won’t have confidence to get latest 640-822. Now We guaranteed latest 640-822 exam training is available in various formats to best suit your needs and learning style.Whether you are a hands-on tactile learner,visually or even a textbook training veteran,Flydumps has latest 640-822 resources that will enable you to pass your Cisco 640-822 test with flying colors. As with Cisco exams, theCisco 640-822 exam is structured to stack or plug into other related courses.The combination of Cisco 640-822 courses builds the complete core knowledge base you need to meet your Cisco 640-822 certification requirements.